|
Ron Stygar Carl Buckland Dale Beuning Forums Help
From sgalaba_at_ix.netcom.com Fri Jan 24 12:58:41 1997 Date: Fri, 24 Jan 1997 14:57:14 -0600 From: Scott Galaba <sgalaba_at_ix.netcom.com> Reply-To: sgalaba_at_ix.netcom.com To: dale_at_unofficialbmw.com Subject: Brake Bleeding Addition for E36 Content-Transfer-Encoding: 7bit X-Status: After reading Steve Bernstein's Brake FAQ, (article on Fabricating a Brake Bleeder Pressure Kit by Al Cote and Jon Lindsay) I found it hard to find a cap to fit the reservoir on an E36. I did find that a (1-1/2 inch black rubber plumbing pipe end cap with clamp)fits. The instructions from Al and Jon are the same for the cap. The only thing different is you tighten the end cap down to the reservoir with a screw driver. I found the end cap at local hardware store for around $2.50. The manufacture of the end cap that I used was Mission Rubber Co. Inc. Whittier, CA. Thanks to Al and Jon ... it's so easy to bleed now! Maybe you could post this as an addition to 'The Unofficial E36 Home Page' in the Brake section. Thanks
Scott Galaba |
