View previous topic :: View next topic |
Author |
Message |
pep357
Joined: 27 Jun 2008 Posts: 9
|
Posted: Mon Oct 28, 2013 6:12 pm Post subject: 93 325i |
|
|
My car makes a metal on metal noise when trying to start but won't start I put new spark plugs and new fuel pump it turns over but won't star I even had a backfire can anyone please advise |
|
Back to top |
|
![](templates/subSilver/images/spacer.gif) |
|
geminiys
Joined: 13 Oct 2004 Posts: 182 Location: SF, California
|
Posted: Fri Nov 01, 2013 11:41 am Post subject: |
|
|
It is very difficult to guess what could be the problem but if you say the engine is turning (means Starter is working) I would start looking to see if Timing Chain is in place. If it is not, most likely the valves are bent. I am assuming it is an Automatic transmission and sits in 'P' while trying to start.
Maybe you can share more information on how the problem occurred? |
|
Back to top |
|
![](templates/subSilver/images/spacer.gif) |
pep357
Joined: 27 Jun 2008 Posts: 9
|
Posted: Sat Nov 02, 2013 12:17 am Post subject: |
|
|
Before that happened the starter made a whining sound so I turned the key back then tried again and it started. It was running fine until a couple days later when I tried to start it up it made that metal sound and would not start |
|
Back to top |
|
![](templates/subSilver/images/spacer.gif) |
geminiys
Joined: 13 Oct 2004 Posts: 182 Location: SF, California
|
Posted: Mon Nov 04, 2013 3:49 pm Post subject: |
|
|
Now I understand the problem. Your starter solenoid is no longer functional. Replace the starter, as solenoid cannot be purchased separately. To replace the starter on I-6 engine you will need to remove the Air Intake Manifold to gain access. Good Luck. |
|
Back to top |
|
![](templates/subSilver/images/spacer.gif) |
pep357
Joined: 27 Jun 2008 Posts: 9
|
Posted: Tue Nov 05, 2013 5:01 pm Post subject: |
|
|
Ok I replaced the the starter that took care of the metal noise and the car turns over and feels like it wants to start but it won't start and there is some backfire when it's trying to start I pulled one code 1A book says its the control unit supply please advise and thank you for your comments |
|
Back to top |
|
![](templates/subSilver/images/spacer.gif) |
|